Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Cotswold
If you live in Cotswold, your chimney cap and crown are doing quiet work all year, and most of that work goes unnoticed until a cap wobbles or a water stain shows up inside. We handle chimney cap and crown work across Cotswold, from cap installation and replacement to crown repair and coating, and we know the housing stock here well enough to know what we’re walking into. Cotswold’s brick ranches and split-levels were mostly built between the 1950s and 1970s, which means a lot of original masonry crowns and clay flue tile are still up there. Whether you’re near Cotswold Elementary or off Randolph Road, we can get a technician out on a booked visit and give you a written estimate before any work starts. Call (888) 848-8714 to set it up – we answer 24/7, with fast dispatch from 7am to 7pm.
Why Cotswold Homeowners Call Chimney Sweep Steele Creek for Chimney Cap & Crown
We’re a chimney company, not a general handyman with a brush. That matters in a neighborhood like Cotswold, where a cap-and-crown visit is usually about the whole top of the chimney – the mortar crown, the flue tile, the flashing, and the cap – not just slapping a new lid on. When we serve Cotswold, we inspect before we recommend anything. If the crown is sound and just needs a seal, we’ll tell you that. If the crown is cracked through and needs recasting, you’ll see the photos that show why.
Our technicians have up to 12 years of experience working on masonry chimneys, and that matters on these mid-century homes. We know that a mortar crown built in 1965 behaves differently from a modern one, and we know what pine litter does to a wet crown over a humid Charlotte summer. We also carry the professional-grade brands homeowners ask about – Gelco and Famco caps, HeatShield resurfacing, DuraFlex liners – and we work with them as a matter of course. That means one call covers the sweep, the inspection, and the repair, with no handoff to a second contractor. We don’t invent review counts or ratings we can’t back up. What we can promise is that the local pro we connect you with is licensed and insured as the state requires, and that the estimate you get is written and sets the final price.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Cotswold
Cap Installation in Cotswold
A new cap is the cheapest protection you can put on a Cotswold chimney. We install stainless multi-flue caps sized to your flue opening, which keep rain, squirrels, and pine debris where they belong – outside. On a home with an original single-flue setup and a later wood or gas insert, the flue opening may not match what the old cap was built for, and we size accordingly.

Cap Replacement in Cotswold
Original steel caps rust through after enough humid summers, and the ones on Cotswold’s older homes often do. Once a cap rusts through or blows loose, water and animals get straight into a flue that may be sized for a retrofitted insert, not the open hearth it was built for. We pull the old one, check the flue tile and flashing underneath, and fit a replacement from Gelco or Famco that’s built to stay put.

Crown Repair in Cotswold
This is the repair most Cotswold requests actually turn into. The original mortar crown on a 1950s-70s brick ranch is thin, and decades of humid summers and a handful of hard freezes crack it. Pine needles and roof grit collect on top, hold moisture, and hide the damage until a cap starts to wobble or a stain shows on the smoke chamber. We chisel out the failed mortar, recast the crown with proper slope and overhang, and make sure water runs off it instead of down the flue.

Crown Coating in Cotswold
Not every crown needs recasting. If the mortar is sound but the surface is rough and beginning to absorb water, a flexible coating seals it and buys years before a full repair. We’ll tell you plainly which one your crown needs – coating or rebuild – and we won’t push a rebuild on a crown that’s still doing its job. Our chimney cap & crown team can walk you through the difference when we’re on site.
Trusted Brands We Service in Cotswold
We work with a set of professional-grade chimney product lines: Gelco and Famco caps, HeatShield ceramic resurfacing, DuraFlex flexible liners, Olympia Chimney, and Copperfield. Those names matter because they’re the materials tradespeople actually use, not the thin stamped caps you’ll find at a big-box store. We don’t claim to stock every part on a truck; what we do is match the right product to the job and follow through. When a Cotswold homeowner asks for a real stainless multi-flue cap or a HeatShield resurfacing of a flue, we can source and install it without a second contractor stepping in.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Cotswold Homes
- Mortar crown cracks from freeze-thaw, hidden under pine litter. Charlotte’s occasional hard freezes crack an aging mortar crown, and the tall pines throughout Cotswold drop needles and grit on top so the crack stays wet and hidden long after a rain.
- Rusted-through or blown-loose single-flue caps. Original steel caps rust out over decades, and once one is loose, squirrels and rain find a flue that was resized for a retrofitted wood or gas insert rather than the open hearth.
- Spalling brick at the crown edge. The crown edge takes the worst of the weather, and shade plus heavy humidity keep the masonry damp longer than in drier regions, so spalling goes unnoticed until pieces start dropping.
- Crowns recast thin by an earlier repair. Some Cotswold chimneys have a patch-job crown poured thin and flat with no overhang, which pools water instead of shedding it and fails early.
Pricing for Chimney Cap & Crown in Cotswold, NC
A typical multi-flue cap installation in Cotswold runs $350 – $900, depending on flue count and whether the cap is a stock size or a custom fit. Crown coating on a sound crown generally runs $325 – $500, and a full crown recast on a Cotswold brick ranch typically runs $475 – $1,200, with the higher end covering larger footprints and spalled brick that needs stitching at the edge. Cap replacement on an existing stack usually lands in the $300 – $600 range. The written estimate is what sets the final price, and the estimate itself is free. We don’t add trip charges or service-call fees. If a crown has a few more seasons left in it, we’ll say so and you can plan the repair for later.
We Also Serve Cities Near Cotswold
The same cap-and-crown work we do in Cotswold, we also do nearby. If you’re in SouthPark, Eastover, Myers Park, or Elizabeth, the housing stock and the climate are much the same, so the repair logic is too. Call (888) 848-8714 to book a visit, with fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed Saturday.
Serving Cotswold, NC – Our Local Coverage Area
We serve Cotswold and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Cotswold
No, a cap over a cracked crown traps water against the mortar and lets it run down the flue liner, so it doesn’t fix the problem. A cap protects the flue opening; the crown is what sheds water off the top of the masonry. Both need to be sound, or water finds the crack and works into the smoke chamber. We’ll inspect the crown and tell you whether it needs recasting or coating before the cap goes on. Call (888) 848-8714 for an exact quote – estimates are free.
You should have the top of the chimney checked once a year here, not every few years. The long humid summers keep masonry damp, the tall pines drop needles and grit onto the crown, and the shade keeps it wet longer, so a small crack has more time to grow before you notice it. Plan the inspection for late summer or early fall, before the first burn of the season. Call (888) 848-8714 to book a visit.
Yes, it does. An insert changes the flue size the cap has to cover, so an original single-flue cap sized for an open hearth may not fit correctly, and a loose fit lets water and animals in. The right cap is sized to the liner that’s actually up there, whether that’s a HeatShield-restored flue or a DuraFlex liner installed with the insert. We size the cap to the flue, not the chimney. Call (888) 848-8714 for an exact quote.
Crown coating seals a sound crown that’s starting to absorb water; a full crown repair replaces failed mortar and recasts the whole thing with proper slope and overhang. Coating is the lighter, cheaper option when the mortar is still holding. A crown that’s cracked through, spalled at the edge, or pooled with water needs the recast. We inspect first and recommend the smaller of the two when it will hold. Call (888) 848-8714 for an exact quote.
Burn dry, seasoned wood, keep the fire hot enough that smoke doesn’t smolder, and don’t damper the flue down overnight. Wet wood and slow, smoky fires load the flue with creosote faster than dry wood and a lively fire, and glazed creosote is what becomes a fire risk and what eats into the mortar at the crown. A yearly sweep keeps buildup from getting ahead of you. Call (888) 848-8714 for an exact quote – estimates are free.
Ready to protect the top of your Cotswold chimney? Call (888) 848-8714 for a free estimate. We answer 24/7, and we run fast dispatch from 7am to 7pm, Sunday through Friday. We’ll inspect the crown and cap before we recommend anything, show you the photos, and put the price in writing. One call covers everything your chimney needs.
Written by the team at Chimney Sweep Steele Creek.